The device, service, Audi 80/90/Coupe 1986-1991 repair - 10.1.8. Adjustment of the hand brake//Audi / songwizard.ru

Audi 80/90/Coupe

since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburetors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
- 10. Brake system
   10.1.2. Brake shoes of forward brakes
   10.1.3. Brake shoes of back brakes
   10.1.4. General adjustment of back brakes (Girling)
   10.1.5. Replacement of brake shoes (all-wheel drive models)
   10.1.6. General adjustment of back brakes (Girling) (all-wheel drive models)
   10.1.7. Forks of pedals of a brake and coupling
   10.1.8. Adjustment of the hand brake
   10.1.9. Removal of the lever of the hand brake
   + 10.2. Hydraulic components
   + 10.3. Anti-blocking system of brakes
+ 11. Steering
+ 12. Body, salon
+ 13. Central air
+ 14. Electric equipment


dfe5d7b3



10.1.8. Adjustment of the hand brake

GENERAL INFORMATION

Hand brake
1. Rotary pin
2. Cover
3. Lever of a parking brake
4. Handle
put on the lever so that the latch on the lever got to a loop on the handle
5. Switching off button
it is wound on a pusher
6. Kompressionny spring
7. Latch
8. Doggie
9. Switch
for an alarm bulb of the hand brake
10. Sheet spring
11. Lock ring
check correctness of installation
12. Cover
13. Equalizer
14. Adjusting nut
15. Bearing
16. Rotary pin
grind off a head for rivet replacement at installation of a new pin
17. Draft
18. Rotary pin
grind off a head for rivet replacement at installation of a new pin

Adjustment of the hand brake

As back brakes are self-regulating, it is necessary for you to carry out their adjustment only after replacement: ropes of the hand brake, supports of brakes, brake disks, brake shoes.

Always in the beginning carry out the general adjustment of back brakes.
PERFORMANCE ORDER
1) tighten an adjusting nut of a rope of a parking brake so that both levers (one of them is specified by an arrow) rose from an emphasis (two mechanics are for this purpose necessary)
2) twirl an adjusting nut (it is specified by an arrow) back on two turns
3) by means of a screw-driver take away the support lever against the stop in turn on both back wheels
4) a rope of the hand brake will pull too strongly if the lever of one of supports departs from an emphasis
5) weaken an adjusting nut of a rope of the hand brake (it is specified by an arrow) so that both levers fell by an emphasis
6) put the car on the hand brake, and then remove
7) check, that both wheels rotated freely