Audi 80/90/Coupe

since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburetors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
- 10. Brake system
   10.1.2. Brake shoes of forward brakes
   10.1.3. Brake shoes of back brakes
   10.1.4. General adjustment of back brakes (Girling)
   10.1.5. Replacement of brake shoes (all-wheel drive models)
   10.1.6. General adjustment of back brakes (Girling) (all-wheel drive models)
   10.1.7. Forks of pedals of a brake and coupling
   10.1.8. Adjustment of the hand brake
   10.1.9. Removal of the lever of the hand brake
   + 10.2. Hydraulic components
   - 10.3. Anti-blocking system of brakes
      10.3.2. Hydraulic pump
      10.3.3. Electronic control unit
      - 10.3.4. Elements ABS of a forward wheel
         10.3.4.1. Sensors of speed of rotation of forward wheels
      + 10.3.5. Elements ABS of back brakes
      10.3.6. General comments on repair
+ 11. Steering
+ 12. Body, salon
+ 13. Central air
+ 14. Electric equipment







dfe5d7b3


10.3.4. Elements ABS of a forward wheel

GENERAL INFORMATION

Elements ABS of a forward wheel (models till January, 1989)

1. Rubber plug
insert into an arm
2. The CV JOINT with a rotor
the external CV JOINT is on sale as spare honor with the established rotor
put D6 glue on a junction of a semi-axis and a wheel nave
3. Sensor of speed
4. Sealing ring
always replace
5. 10 N of m.
6. Самоконтрящаяся nut
moment of an inhaling of 265 N of m.
always replace
twist and turn off only when the car costs on the earth
at a twisting put D6 glue on a carving
7. Rack of the bearing of a nave of a wheel
is on sale as the spare part with the established plug for fastening of the sensor of speed
8. Arm
for fastening of wires
9. 10 N of m.

Elements ABS of forward brakes (models after January, 1989)

1. Semi-axis and CV JOINT
is on sale as the spare part with
the established rotor
does not stick together with a wheel nave
the number of teeths on a rotor is reduced by a half
in comparison with old updating
get the sensor of speed before semi-axis removal a little
2. The sensor of speed of rotation of a wheel is identical for
left and right parties
for removal: simply pull out it from a nest
for installation: establish fingers against the stop
3. Fixing plug
for installation: grease with liquid of the brake
the cylinder also establish in a nest of a rack of the bearing of a nave against the stop
4. 200 N of m.
after a twisting till the demanded moment of an inhaling turn in addition on a turn quarter (90о)
always replace
twist / turn off only when the car costs on the earth
5. Rack of the bearing of a nave
is on sale as the spare part with an opening for installation of the fixing plug and the sensor of speed