Audi 80/90/Coupe

since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburetors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
- 10. Brake system
   10.1.2. Brake shoes of forward brakes
   10.1.3. Brake shoes of back brakes
   10.1.4. General adjustment of back brakes (Girling)
   10.1.5. Replacement of brake shoes (all-wheel drive models)
   10.1.6. General adjustment of back brakes (Girling) (all-wheel drive models)
   10.1.7. Forks of pedals of a brake and coupling
   10.1.8. Adjustment of the hand brake
   10.1.9. Removal of the lever of the hand brake
   + 10.2. Hydraulic components
   - 10.3. Anti-blocking system of brakes
      10.3.2. Hydraulic pump
      10.3.3. Electronic control unit
      - 10.3.4. Elements ABS of a forward wheel
         10.3.4.1. Sensors of speed of rotation of forward wheels
      + 10.3.5. Elements ABS of back brakes
      10.3.6. General comments on repair
+ 11. Steering
+ 12. Body, salon
+ 13. Central air
+ 14. Electric equipment







dfe5d7b3


10.3.4.1. Sensors of speed of rotation of forward wheels

Cнятие

PERFORMANCE ORDER
1) remove a fastening bolt (it is specified by the bottom arrow) and get the sensor of speed
2) replace a sealing ring of the sensor
3) grease a sealing ring and the sensor of speed with the same greasing that was used for greasing of the mechanism of brakes
4) establish the sensor in a rack nest so that the polikhlorvinilovy tip concerned a rotor on the CV JOINT
5) establish a new fixing bolt and tighten it to 10 N of m, holding the sensor of speed, having pressed it to a rack of the bearing of a nave
6) insert the rubber plug of wires into an arm on a rack of the bearing of a nave (it is specified by the top arrow)

After the sensor of speed was removed and established several times, replace an old polikhlorvinilovy cap and establish new, a detail 437 927 809. It is necessary for maintenance of a demanded air gap.

Plait of wires of the sensor of speed of a forward wheel, installation

PERFORMANCE ORDER
put on a plait of wires the rubber plug (the top arrow) and stretch it to a rack of the bearing of a nave

insert a plait of wires in the rubber plug into an arm on a body (the bottom arrow)

fix a plait a wire by means of a clip in a point specified by an average arrow

Sensor of speed of the left forward wheel, detachment

PERFORMANCE ORDER
remove the connection socket from an arm (it is specified by an arrow) and disconnect it from the sensor

Sensor of speed of the right forward wheel, detachment

PERFORMANCE ORDER
weaken a fixing collar (it is specified by an arrow)

remove the socket of connection and disconnect it from the sensor