Audi 80/90/Coupe

since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburetors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
- 11. Steering
   11.2. Shaft and casing of a steering column
   11.3. A power absorbing steering column
   11.4. Steering drive
   11.5. Pipeline of high pressure / return pipeline
   11.6. Adjustment of a free wheeling of a lath of a steering
   11.7. Maple belt
   + 11.8. System of hydrostrengthening of a steering
+ 12. Body, salon
+ 13. Central air
+ 14. Electric equipment


dfe5d7b3



11.3. A power absorbing steering column

Removal

PERFORMANCE ORDER
1) disconnect a wire of the negative plug of the accumulator for shutdown of system of an airbag of safety
2) establish forward wheels directly
3) remove a safety airbag
4) remove a casing of the block of switches of a steering column (it is specified by shooters)
5) disconnect the socket of connection of an airbag of the safety, located under a casing of the block of switches of a steering column. For this purpose, by means of a screw-driver, press a uvula (it is specified by an arrow) on the brink of the socket
6) remove a steering wheel
7) weaken a clip on the block of switches of a steering column and remove the block of switches
8) remove screws (are specified by shooters), fixing an instrument guard
9) disconnect the socket of connection and remove an instrument guard
10) disconnect the socket of the lock of ignition from the lock of a steering column
11) turn off four bolts of fastening of the knee buffer and remove a cap (it is specified by an arrow)
12) disconnect control sockets from the knee buffer and clean them aside
13) remove the knee buffer
14) disconnect the basis of a shaft of a steering column (it is specified by shooters) from a fixing arm
15) by means of a screw-driver in length about 15 mm, accurately remove a cover from a shaft of a steering column
16) turn off nuts (are specified by shooters), fixing a casing of a steering column / a fixing plate to a fixing arm
17) lower a steering column down and turn it so that it it was possible to remove from below dashboards

Installation

PERFORMANCE ORDER
1) establish a steering column from below in a dashboard opening
2) establish a steering column / a fixing plate on a fixing arm. Insert bolts
3) insert a key into the ignition lock
4) unlock the lock of a steering column that it was possible to rotate a shaft of a steering column
5) press the basis of a steering column to a tube with flanges and to a fixing arm by means of flat-nose pliers. Connect them by means of bolts
6) tighten fastening nuts (are specified by shooters) steering column and arm
7) connect the socket of the lock of ignition to the lock of a steering column

Prevention

Do not try to straighten elements of a steering or to carry out on them repair welding work.