Audi 80/90/Coupe

since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburetors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
- 11. Steering
   11.2. Shaft and casing of a steering column
   11.3. A power absorbing steering column
   11.4. Steering drive
   11.5. Pipeline of high pressure / return pipeline
   11.6. Adjustment of a free wheeling of a lath of a steering
   11.7. Maple belt
   - 11.8. System of hydrostrengthening of a steering
      11.8.1. Technical characteristics
      11.8.2. Pumping / filling of hydraulic liquid
      11.8.3. Check on tightness (at the working engine)
      11.8.4. Steering transfer
      11.8.5. Pump of the hydraulic booster of a steering (Vickers)
+ 12. Body, salon
+ 13. Central air
+ 14. Electric equipment







dfe5d7b3


11.8.2. Pumping / filling of hydraulic liquid

GENERAL INFORMATION

Prevention

Do not use old hydraulic liquid.


Arrangement of marks in a tank with liquid for the power steering


PERFORMANCE ORDER
1) add hydraulic liquid to a mark the MOVE
2) lift the car by means of a jack and at the switched-off engine sharply turn a steering wheel from one extreme situation to another several times for pumping of system of hydrostrengthening
3) add hydraulic liquid to a mark the MOVE
4) start the engine and let's to it work in a single mode about 2 minutes, wheels thus should stand directly
5) observe hydraulic liquid in a tank
6) after in hydraulic liquid vials will cease to appear, muffle the engine and check liquid level; if it is necessary, add hydraulic liquid to a mark the MOVE

The system of hydrostrengthening of a steering is pumped over automatically after a while at the working engine.

System of cooling of hydraulic liquid

1. Inlet hose
2. Arm
3. 10 N of m, always replace
4. Okhladitelny tube
5. Collar
6. A tank, check liquid level in a tank after the engine will work within 2 minutes, wheels thus should stand directly
muffle the engine, check level of liquid and add to a mark the MOVE if it is necessary
7. 10 N of m.
always replace
8. Collar
9. Collar
10. Sealing rings
always replace
11. "Banjo" bolt
inhaling moment: 50 N of m.