Audi 80/90/Coupe

since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburetors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
- 11. Steering
   11.2. Shaft and casing of a steering column
   11.3. A power absorbing steering column
   11.4. Steering drive
   11.5. Pipeline of high pressure / return pipeline
   11.6. Adjustment of a free wheeling of a lath of a steering
   11.7. Maple belt
   - 11.8. System of hydrostrengthening of a steering
      11.8.1. Technical characteristics
      11.8.2. Pumping / filling of hydraulic liquid
      11.8.3. Check on tightness (at the working engine)
      11.8.4. Steering transfer
      11.8.5. Pump of the hydraulic booster of a steering (Vickers)
+ 12. Body, salon
+ 13. Central air
+ 14. Electric equipment







dfe5d7b3


11.8.5. Pump of the hydraulic booster of a steering (Vickers)

GENERAL INFORMATION

Pump of the hydraulic booster of a steering (Vickers)

1. 45 N of m.
2. Sealing ring
always replace
3. Tube of a high pressure
moment of an inhaling of fastening: 45 N of m.
4. Sealing ring
always replace
5. 20 N of m.
6. Arm
7. 20 N of m.
8. 50 N of m.
9. Sealing ring
always replace
10. A soaking-up hose
11. Sealing ring

12. Lopastna pump
there are lopastny pumps of ralichny types
before installation, fill soaking-up part with hydraulic liquid and повращайте the pump that liquid began to leave the target channel
13. Tension device
14. Bolt / nut of the tension device
15. 20 N of m.
16. Pulley of a maple belt
establish a mark "4Z" forward
17. 25 N of m.
18. Maple belt, 12.5x992 mm

Prevention

The system of hydrostrengthening is filled with hydraulic liquid, G 002 000 detail.


Tension of a maple belt



PERFORMANCE ORDER
1) weaken a nut 1
2) weaken a bolt 2
3) turn a nut 3 on the tension device for a belt tension
4) a belt will pull correctly if it caves in under the pressure of a finger approximately on 10 mm in the middle between two pulleys
5) tighten a bolt 2
6) tighten a nut 1