Two washers with chasheobrazny dredging can be in case of need established.
Adjustment of a bearing element of components of a door
The window and door framework too should be adjusted.
PERFORMANCE ORDER |
|
1) weaken bolts |
2) close a door |
3) press on bearing element of components of a door in the direction opposite to a roof and a rack |
4) the assistant should tighten at first bottom, and then the top bolts |
5) 20 N of m. |
6) be convinced that the bearing element is established, having pressed on top more strongly |
7) do not press a door framework |
8) check all sizes |
|
Holder of components of a door, sizes
|
in drawing the cross-section section of the left door is shown
with = 3.5 + 1 mm d= 8.1 + 1 mm 1–sealing flange 2–door frame 3–decorative overlay of a door 4–window 5–window sealing laying 6–internal door sealing laying 7–sealant 8–a sealant at a window |
the sealing edge 7 should have contact on all contour of a rack and a decorative overlay of a roof 3
the external sealing flange of a window 8 should not support a decorative overlay of a roof 3 |