Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburetors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
- 13. Central air
13.2. Pressure switches
13.3. Valve of descent of water
13.4. Wedge-shaped belt of the compressor of the conditioner
13.5. Check of vacuum system
13.6. Places of connections of lines of a coolant, throttle
13.7. Conditioner compressor
13.8. Coupling of the compressor of the conditioner
+ 14. Electric equipment
13.6. Places of connections of lines of a coolant, throttle
| GENERAL INFORMATION |
Connection in the line of a high pressure (model with the 5-cylinder engine)
| Disunite this connection before remove the condenser in cars with the 5-cylinder engine; inhaling moment: 16.5 N of m. |
Connection of the line of a coolant to the evaporator
| Before tightening a bolt of this connection, be convinced that lines are not pressed. Inhaling moment: 16.0 N of m. |
Throttle, removal and installation
| PERFORMANCE ORDER | ||||
|
Ring consolidations
| Before establishing, oil ring consolidations of a coolant. |
Prevention
|
Technical characteristics of ring consolidations
|
and (mm)
|
b (mm)
|
| Compressor (area of low pressure) |
17.2
|
1.8
|
| Ring consolidation on an evaporator exit | ||
| Ring consolidation of the store | ||
| Compressor (area of a high pressure) |
14.0
|
1.8
|
| Ring consolidation on a condenser entrance | ||
| Ring consolidation on an evaporator entrance |
10.8
|
1.8
|
| Ring consolidation of the switch of a high pressure of a coolant |
9.3
|
1.8
|
| Ring consolidation of the switch of low pressure | ||
| Ring consolidation of the safety switch | ||
| Ring consolidation on a condenser exit |
7.5
|
1.8
|
| Ring consolidation of connection in the line of a high pressure of a coolant (only for cars with the 5-cylinder engine) | ||
| Ring consolidation of a throttle |
7.5
|
1.5
|