Audi 80/90/Coupe

since 1986-1991 of release

Repair and car operation

Audi 80/90/Coupe
- 1.2. Car identification
   1. Maintenance instruction
   1.3. Arrangement of identification plates
   1.4. Dashboard
   + 1.5. Car service
   - 1.6. Independent service of the car
      1.6.2. Small-sized spare wheel
      1.6.3. Wheel replacement
      + 1.6.4. Safety locks
      - 1.6.5. Replacement of bulbs Headlights of forward light Forward indexes of turns and marker lights A back block headlight on a back wing The central stoplight on back glass Back fog lights and headlights of a tail light in a trunk lid Bulbs of illumination of registration plate Back lateral dimensional lamp Plafond of illumination of salon Bulbs for reading cards Fog lights Lamp of illumination of an impellent compartment Lamp of illumination of a luggage carrier
      1.6.6. Car audio replacement
      1.6.7. Car lifting
      1.6.8. General rules of towage
   + 1.7. Specifications
   1.8. Capacities
   1.9. Sizes
   1.10. Loadings
   1.11. Schedule preventive car servicings / greasings
+ 2. Engines, carburetors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
+ 13. Central air
+ 14. Electric equipment

dfe5d7b3 Forward indexes of turns and marker lights


Open a cowl and prop up it.

Remove casings from headlights.

To replace a bulb, get headlights of the index of turns and a marker light. For removal of headlights press on both clips in the direction of arrows, and at the same time вытолкните headlights forward.

Remove headlights.

Turn a cartridge with a bulb counter-clockwise and pull out it.

Press an old bulb into a cartridge, turn it counter-clockwise, get and establish a new bulb.

Insert a cartridge with a bulb into the case of a headlight and turn clockwise so that it densely became into place.

Establish into place a headlight of the index of turns and a marker light, having inserted clips into the corresponding openings and having inserted both plastic uvulas on the headlight case into their openings. Insert a headlight as it is possible further.