Audi 80/90/Coupe

since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburetors
3. Greasing system
+ 4. Cooling system
- 5. Fuel system
   - 5.2. Systems of injection of fuel
      5.2.1.2. Specifications (4-cylinder models)
      5.2.1.3. Components of system of injection for 5-cylinder models
      5.2.1.4. Specifications (5-cylinder models)
      5.2.1.5. Starting position of a plate of the sensor of an air stream
      5.2.1.6. Free wheeling of a plate of the sensor of an air stream
      5.2.1.7. Lever of a plate of the sensor of an air stream
      5.2.1.8. An operating plunzher
      5.2.1.9. Throttle valve
      5.2.1.10. Rope of management of a butterfly valve
   5.2.2. Fuel injectors (20-klapanny models)
   + 5.2.3. Electronic control system of the MPI engine
+ 6. Exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
+ 13. Central air
+ 14. Electric equipment







dfe5d7b3


5.2.1.10. Rope of management of a butterfly valve

GENERAL INFORMATION

Rope of management throttle zaslonoky, arrangement of components (4-and 5-cylinder models
)
 
1. Throttle case
2. Basic arm
3. Rotary plug
for removal of the lever of a pedal break off fixing ledges (do not use repeatedly damaged rotary plugs)
4. Pedal lever
acts in film only together with rotary plugs
5. Gas pedal
6. Rotary plug
7. Rope of management of a butterfly valve
8. Clamp

Adjustment

PERFORMANCE ORDER
1) at completely squeezed out pedal of gas the lever of the throttle valve should reach only just the provision of completely open butterfly valve (a free wheeling on the throttle lever – at most 1 mm)
2) if it not so
adjust a rope, inserting a clamp (it is specified by an arrow) at a basic arm

Removal

PERFORMANCE ORDER
1) disconnect a rope from a basic arm of a pedal and the lever of the throttle valve
2) break off fixing ledges from within salon (do not use repeatedly damaged ropes) and extend a rope through an engine compartment
3) replace laying and ring consolidations
4) fix connections of hoses by screw or spring clips
5) for the correct work of components of electric system tension of at least 11.5 volts is necessary

Prevention

Inflammably! Do not smoke and do not bring to area of repair anything from this that can ignite fuel.