Audi 80/90/Coupe

since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburetors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
- 7. Ignition system
   7.1.2. Specifications (4-cylinder models)
   7.1.3. Components of system of ignition for 5-cylinder models
   7.1.4. Specifications (5-cylinder models)
   7.1.5. CIS-E Motronic control unit (the alarm block)
   7.1.6. Distributor rotor
   7.1.7. Ignition distributor (4-cylinder models)
   7.1.8. Ignition distributor (5-cylinder models)
   7.1.9. Components of system of ignition for 20-klapanny models
   7.1.10. Specifications (20-klapanny models)
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
+ 13. Central air
+ 14. Electric equipment





7.1.7. Ignition distributor (4-cylinder models)

GENERAL INFORMATION

Prevention

On a rotor there should be R1 label (for the cars equipped with the generator of the Hall).


Installation

PERFORMANCE ORDER
1) And – at the established engine establish a flywheel in the top dead point – the cylinder 1
2) In – at the removed engine – establish a label on a vibrogasitel (pulley) opposite to a label on a belt cover
3) level a label on a cam-shaft asterisk with a cover of a head of cylinders (it is specified by an arrow)
4) level a cut of a ledge of a drive with a carving opening

Prevention

The head of a tightening bolt of the distributor is closed by a seal which it is necessary to remove if the distributor for any reason acts in film.


5) establish the distributor so that the rotor was directed on a label for the cylinder 1 on a distributor casing
6) clear a distributor cover before installation, check it about cracks and soot traces as result of an iskreniye, if necessary replace
7) adjust a corner of an advancing of ignition
8) tighten tightening a distributor bolt (25 N of m)
9) establish a new seal on a long bolt of the distributor

Prevention

At replacement of the control unit check installation of a corner of an advancing of ignition, if necessary adjust.