Audi 80/90/Coupe + 1.2. Car identification + 2. Engines, carburetors
3. Greasing system + 4. Cooling system + 5. Fuel system + 6. Exhaust system + 7. Ignition system - 8. Transmission 8.1.2. A fork - the main cylinder of coupling 8.1.3. Press coupling disk 8.1.4. Malfunctions of coupling - 8.2. Mechanical transmission 012 8.2.2. Lever mechanism of the lever of gear shifting 8.2.3. Removal and transmission installation 8.2.4. Differential mechanisms + 8.3. Mechanical transmission 01А + 8.4. Automatic transmission 089 + 8.5. Automatic transmission 087 8.6. Dismantling and assembly of automatic transmissions 8.7. Block of valves + 8.8. Automatic transmission 097 + 9. Suspension brackets, wheels + 10. Brake system + 11. Steering + 12. Body, salon + 13. Central air + 14. Electric equipment
|
Gear shifting lever assembled
1. Gear shifting lever it can be inserted into a spherical support only in one situation 2. Lock ring always replace the roundish party should be turned to a spherical support remove before removal of a spherical support 3. 25 N. 4. Lamellar spring 5. Coulisse 6. Draft of gear shifting color code: blue = for engines with 5 cylinders 7. Cover 8. Clip 9. 25 N of m. 10. 20 N of m. always replace the screw is greased with hermetic 11. Basis of the lever of gear shifting fastens on a floor by means of AKD 512 001 hermetic 12. 10 N of m. 13. A switching fork 14. 10 N of m.
|
15. A directing cup it is necessary to establish restrictions for movement of a spherical support at the left and on the right emphasis establish so that at inclusion of transfer of a backing the lever was inclined to the left 16. Spherical support establish a spring and the plug in a spherical support, and then establish the gear shifting lever so that the spring and the plug were on the correct party in the moving direction establish a spherical support before installation of a stoprny ring 17. Plug the roundish end is turned to the gear shifting lever 18. Spring 19. Axis of the lever of gear shifting 20. Rasporny plug 21. Lock ring. 22. Cover for removal unscrew the screw 23. Screw 24. Handle |
Prevention
Do not grease the lever mechanism of the lever of gear shifting.
Adjustment
PERFORMANCE ORDER |
1) move the gear shifting lever to neutral situation |
2) remove the lever handle, unscrew the screw of fastening of a cover of the lever and remove a cover |
|
3) weaken a bolt (it is specified by an arrow)
|
4) establish the gear shifting lever vertically (as far as possible) |
|
Check
PERFORMANCE ORDER |
|
1) establish the gear shifting lever so that both uvulas on a spherical support were at identical distance of "a" (it is specified by shooters) from a directing cup |
2) tighten a bolt and check, that the lever did not move |
3) check operation of the mechanism of gear shifting, include all transfers in turn |
4) 3-я/the 4th transfers should be in the same plane, as neutral |
5) check work of a safety latch of transfer of a backing. If it does not work, turn off screws and turn directing cup a little |
6) establish a cover and the handle of the lever of gear shifting |
|
|
|