Audi 80/90/Coupe

since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburetors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Ignition system
- 8. Transmission
   8.1.2. A fork - the main cylinder of coupling
   8.1.3. Press coupling disk
   8.1.4. Malfunctions of coupling
   - 8.2. Mechanical transmission 012
      8.2.2. Lever mechanism of the lever of gear shifting
      8.2.3. Removal and transmission installation
      8.2.4. Differential mechanisms
   + 8.3. Mechanical transmission 01А
   + 8.4. Automatic transmission 089
   + 8.5. Automatic transmission 087
   8.6. Dismantling and assembly of automatic transmissions
   8.7. Block of valves
   + 8.8. Automatic transmission 097
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
+ 13. Central air
+ 14. Electric equipment







dfe5d7b3


8.2.4. Differential mechanisms

GENERAL INFORMATION

Differential assembled

1. Differential case
at replacement of the case of differential adjust installation of a zbchaty wreath
2. Bolt of a gear wreath
use bolts only the demanded specification
tighten evenly in a diagonal order to 90 N of m.
3. The big roller bearing – an internal holder
to establish by means of the plug 40-21
4. Gear wheel of a drive of a speedometer
it is possible to remove, without removing a transmission
5. A big roller bearing – an external holder
establish by means of the VW 295 and VW 551 tools
6. S1 washer, note thickness
7. Cover
8. Persistent washer
before installation grease with transmission oil
9. Satellites
10. Axis of satellites
remove by means of a drift after removal of a pin of an axis of satellites
11. Pin of an axis of satellites
remove by means of a drift
12. Gear wheels of semi-axes
13. Gear wreath
the gear wreath and leading gear wheel are adjusted to each other
at pair replacement gear the wreath / leader a gear wheel carry out adjustment
installation: heat up to 100 ° With and establish by means of centering pins
14. A small roller bearing – an internal holder
to establish by means of the plug 40-21
15. A small roller bearing – an external holder
16. S2 washer
note thickness