Audi 80/90/Coupe

since 1986-1991 of release

Repair and car operation

Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburetors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Ignition system
- 8. Transmission
   8.1.2. A fork - the main cylinder of coupling
   8.1.3. Press coupling disk
   8.1.4. Malfunctions of coupling
   + 8.2. Mechanical transmission 012
   + 8.3. Mechanical transmission 01А
   - 8.4. Automatic transmission 089
      8.4.2. Lever and rope of the lever of gear shifting
      8.4.3. Lock of automatic gear shifting
      8.4.4. Mechanism of management of a butterfly valve
      8.4.5. Removal and transmission installation
      8.4.6. Check of the moments of gear shifting
      8.4.7. Main transfer
      8.4.8. Differential
   + 8.5. Automatic transmission 087
   8.6. Dismantling and assembly of automatic transmissions
   8.7. Block of valves
   + 8.8. Automatic transmission 097
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
+ 13. Central air
+ 14. Electric equipment


8.4.5. Removal and transmission installation


1) remove the accumulator
2) remove the top bolts of fastening of the engine and a transmission
3) disconnect a wire of grounding of a transmission
4) disconnect the socket of connection of a speedometer
5) establish a support under the engine
6) lift the car
7) remove bolts from forward fastening of the engine
8) remove a forward exhaust pipe
9) remove the hydrotransformer filter
10) remove bolts of fastening of the hydrotransformer (3 bolts)
11) disconnect hoses of a radiator of liquid of cooling of an automatic transmission on a back part of the engine, under the accumulator shelf
12) remove the filter on the right side
13) disconnect semi-axes from the main transfer
14) disconnect feeding tube of liquid of cooling of an automatic transmission
15) remove an arm of a rope of gear shifting and disconnect a rope from a transmission
16) remove plastic clips from ropes of seat belts
17) disconnect an accelerator rope from the lever of switching of a transmission
18) remove cross-section fastening behind a transmission
19) lift a transmission by means of the lift and remove bolts of fastening of a transmission
20) lower the lift and lift the engine, having lifted an engine support (the transmission thus slightly will bend for simplification of removal)
21) remove remaining bolts of fastening of a transmission and the engine
22) separate the spherical hinge / case of the bearing of the left wheel and pull out a semi-axis
23) disconnect a transmission from the engine
24) accurately lower the engine, thus support the hydrotransformer that it did not fall


Installation is carried out upside-down removals, thus pay attention to the following:

establish and twirl bolts of fastening of a transmission the last.