Audi 80/90/Coupe

since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburetors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Ignition system
+ 8. Transmission
- 9. Suspension brackets, wheels
   9.1.1. Elimination of resonance / vibration of a cross-piece (4-cylinder models)
   9.1.2. Change of a design of a forward suspension bracket
   9.1.3. Semi-axis
   9.1.4. Suspension bracket rack
   9.1.5. CV JOINTS
   9.1.6. Suspension bracket rack (all-wheel drive models)
   9.1.7. CV JOINTS (all-wheel drive models)
   - 9.2. Back suspension bracket
      9.2.1. Oil cap
      9.2.2. Bearings of a nave of a wheel
      9.2.3. Removal and installation of the back bridge
      9.2.4. Suspension bracket rack
      9.2.5. Change of a design of a back suspension bracket
   + 9.3. Wheels and tires
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
+ 13. Central air
+ 14. Electric equipment







dfe5d7b3


9.2.3. Removal and installation of the back bridge

Removal

PERFORMANCE ORDER
1) remove back wheels
2) remove the equalizer of ropes of the hand brake (the top arrow)
3) remove a rope of the hand brake from clips on fixing arms (the bottom shooters)
4) remove directing plug of a rope of the hand brake from fixing arms (are specified by shooters)
5) disconnect brake hoses from brake tubes (the right arrow)
6) remove nuts of fastening of the hook-on device (the left arrow). Do not take out bolts
7) disconnect a spring of a regulator of pressure of brakes from the back bridge

8) remove a bolt, fixing a cross-section jet bar (the bottom arrow)
9) remove bolts of the bottom fastening of a rack of a suspension bracket (the top arrow)
10) remove bolts of fastening of the hook-on device (for performance of this operation two persons are necessary)
11) remove the back bridge

Installation

Installation is made in sequence, return to removal. Thus pay attention to the following:

pump over brake system, adjust a parking brake.