Audi 80/90/Coupe + 1.2. Car identification + 2. Engines, carburetors
3. Greasing system + 4. Cooling system + 5. Fuel system + 6. Exhaust system + 7. Ignition system + 8. Transmission - 9. Suspension brackets, wheels 9.1.1. Elimination of resonance / vibration of a cross-piece (4-cylinder models) 9.1.2. Change of a design of a forward suspension bracket 9.1.3. Semi-axis 9.1.4. Suspension bracket rack 9.1.5. CV JOINTS 9.1.6. Suspension bracket rack (all-wheel drive models) 9.1.7. CV JOINTS (all-wheel drive models) + 9.2. Back suspension bracket + 9.3. Wheels and tires + 10. Brake system + 11. Steering + 12. Body, salon + 13. Central air + 14. Electric equipment
|
Forward suspension bracket – drafts and semi-axes
1. Rubber plug it is established only on models with 4-cylinder engines 2. Stabilizer of cross-section stability 3. Plug of the stabilizer of cross-section stability 4. 35 N of m. 5. Arm 6. Clip it is necessary to establish the plug of the stabilizer of cross-section stability correctly 7. 40 N of m. 8. 40 N of m. after a twisting till the demanded moment of an inhaling turn in addition on a turn quarter (90 °) 9. Bolt and washer always replace 10. Plug of the lever of a forward suspension bracket 11. Rubber plug of the stabilizer of cross-section stability 12. 65 N of m. 13. Spherical hinge note the provision of installation at removal from a rack of the bearing of a nave of a wheel adjust disorder of forward wheels after installation 14. Lever of a forward suspension bracket differ on a design on the left and right side 15. Plug insert into the rubber plug
|
16. Connecting draft establish so that sides were at right angle to the direction of movement of the car 17. 35. N of m. turn in addition on a turn quarter always replace 18. Washer always replace 19. Plug of the stabilizer of cross-section stability 20. Bolt the head should look forward 21. 65 N of m. 22. Plug 23. 20 N of m. 24. Back plug of a cross-piece of a forward suspension bracket 25. Cross-piece of a forward suspension bracket various updatings for models with 4-and 5-cylinder engines tighten fastenings in the following order:
1. The back left 2. The back right 3. The forward left 4. The forward right 26. Forward plug of a cross-piece of a predny suspension bracket |
Prevention
Do not try to carry out welding works or to level elements of a forward suspension bracket which are responsible for fastening and installation of wheels. At repair always replace always replace all bolts, washers and самоконтрящиеся the nuts, fixing elements of a suspension bracket, such as a cross-piece of a forward suspension bracket, suspension bracket levers, the stabilizer of cross-section stability, spherical hinges etc.
|
|