Audi 80/90/Coupe

since 1986-1991 of release

Repair and car operation


Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburetors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Ignition system
+ 8. Transmission
- 9. Suspension brackets, wheels
   9.1.1. Elimination of resonance / vibration of a cross-piece (4-cylinder models)
   9.1.2. Change of a design of a forward suspension bracket
   9.1.3. Semi-axis
   9.1.4. Suspension bracket rack
   9.1.5. CV JOINTS
   9.1.6. Suspension bracket rack (all-wheel drive models)
   9.1.7. CV JOINTS (all-wheel drive models)
   + 9.2. Back suspension bracket
   - 9.3. Wheels and tires
      9.3.2. Disorder / convergence of wheels
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
+ 13. Central air
+ 14. Electric equipment


dfe5d7b3

9.3. Wheels and tires

9.3.1. Technical characteristics
GENERAL INFORMATION

Model
Size of the tire
Wheels
Depth of a disk/diameter of a ring of bolts of fastening of a wheel
Audi-80
175/70 HR 14
5-1/2 J x 14*
45/108
Audi-90
195/60 HR 14
6 J x 14
45/108
Spare wheel
115/70 R 15
4 J x 14
56/108
125/90 R 15
4 J x 14
45/108

* wheels with steel disks

Wheel assembled

1. Tire
on forward wheels it is recommended to establish tires with deeper protector
establish tires of only identical type and with identical drawing of a protector
2. A fixing spring for balancing грузика
3. Balancing грузик
on cast disks грузики fasten by means of glue
4. Wheel cap
 5. Bolt of fastening of a wheel
inhaling moment: 110 H.м.
М14 x 1.5 x 27.5 mm
6. Wheel disk
5-1/2J the X-th 14, depth of a rim of 45 mm (for wheels with steel disks)
6 J X 14, depth of a rim of 45 mm (a disk from easy alloys)
7. Chamber valve
establish the new valve at wheel replacement

Wheel with a light-alloy wheel

1. Tire
with a view of safety of the tire should be replaced only with pairs
on forward wheels it is recommended to establish tires with deeper protector
establish tires of only identical type and with identical drawing of a protector
2. Balancing грузики
for installation: clear a wheel rim of oil and greasing, remove a protective film with грузика and paste it on a disk
3. A light-alloy wheel – trellised design 6J x 14
4. Nave cap
5. Cap
the blocking cylinder is established
6. Blocking cylinder
it is established on a wheel bolt
7. Bolt of fastening of a wheel
inhaling moment: 110 H.м.
М14 x 1.5 x 27.5 mm
8. Chamber valve
establish the new valve at wheel replacement